| Check all connections in the charging system. Grounds are usually the culprit but a bad connection anywhere in the system can cause the regulator to overheat. 
 I recommend removing any solder connections in the system. My bird would fly fine for 15 minutes or so before I would lose all electrical power. 10 minutes later everything would come back on… rinse, repeat. It was a bad solder joint that would heat up and lose its connection then reconnect after it cooled off. Impossible to detect on the ground as a bad solder joint looks exactly like a good one. Problem went away after replacing soldered joints with crimps.
 _________________
 Thorp T18
 O-320-B3B (160 HP)
 68x74 Sterba Propeller
 
 "The joke in aviation is, 'If you want to make a million, you'd better start with £10m.' "  -Bruce Dickinson
 
 
 |