| Thorp Air Command - T18.net http://thorp18.com/thorpforum/ |
|
| Jack http://thorp18.com/thorpforum/viewtopic.php?f=7&t=8534 |
Page 1 of 1 |
| Author: | Savalas [ Thu Sep 10, 2020 5:07 am ] |
| Post subject: | Jack |
I need to change my tires and was curious what everyone was using to jack up the plane? |
|
| Author: | Jeff J [ Thu Sep 10, 2020 8:07 am ] |
| Post subject: | Re: Jack |
I use a small floor jack. |
|
| Author: | Jeff J [ Thu Sep 10, 2020 8:11 am ] |
| Post subject: | Re: Jack |
There are some other ideas in this thread: viewtopic.php?f=29&t=8324&p=20832&hilit=Jack#p20832 |
|
| Author: | david read [ Thu Sep 10, 2020 8:58 pm ] |
| Post subject: | Re: Jack |
I use a harbor freight engine hoist with a seat belt around the motor mount. Slide it a bit to which ever side you want to lift. |
|
| Author: | Jim Mantyla [ Thu Nov 05, 2020 10:18 am ] | ||
| Post subject: | Re: Jack | ||
Guys, I tapped the hole on the bottom of the gear leg with a 5/16 NC thread. I then install a 5/16" socket head cap screw and washer. This gives me a secure place for my Princess Auto/Harbor freight floor jack. I attached a picture. I find that this allows me to lift the wheel without having to remove the gear leg fairings. Regards, Jim
|
|||
| Author: | Ryan Allen [ Thu Nov 05, 2020 1:42 pm ] |
| Post subject: | Re: Jack |
I use a floor jack, but I have to remove my wheel pants |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|