Thorp Air Command - T18.net
http://thorp18.com/thorpforum/

T18 Spar Extrusions
http://thorp18.com/thorpforum/viewtopic.php?f=48&t=8102
Page 1 of 1

Author:  DanaL [ Sun Jun 25, 2017 6:15 am ]
Post subject:  T18 Spar Extrusions

Upper and lower extrusions for the center wing. Will trade for S18 extrusions/spar or new set of S18 plans so I can have the signed contract with Cubes.
Extrusions are in central South Carolina, all shipping expenses are on you.

Dana LaBounty

Author:  mmp1 [ Thu Dec 14, 2017 12:16 am ]
Post subject:  Re: T18 Spar Extrusions

Standard T-18 wing?

Author:  DanaL [ Thu Dec 14, 2017 6:51 am ]
Post subject:  Re: T18 Spar Extrusions

As the header says, T18 wing. These are the standard unworked extrusions long enough for the standard center section. I've not measured for exact length but seems to be about 12ft.

Regards,
Dana LaBounty

Author:  fytrplt [ Thu Dec 14, 2017 1:56 pm ]
Post subject:  Re: T18 Spar Extrusions

S-18s use the same center spar, just cut down.

Author:  DanaL [ Thu Dec 14, 2017 8:01 pm ]
Post subject:  Re: T18 Spar Extrusions

Understood. I was thinking that if someone wanted the standard wing that these extrusions could be made use of as opposed to me ruining them just to make the S18 center spar from them. They are still available.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/