| Thorp Air Command - T18.net http://thorp18.com/thorpforum/ |
|
| Rivet guns http://thorp18.com/thorpforum/viewtopic.php?f=36&t=7796 |
Page 1 of 1 |
| Author: | flyingfool [ Fri Jul 10, 2015 11:04 am ] |
| Post subject: | Rivet guns |
What size rivet gun is recommended for a thorp project? I know little to nothing really and see that they list them as 2x, 3x 4x etc. What does this mean and which one is recommended. Going to Oshkosh and figure I may get the best deal there, at least for a new rivet gun. I'd rather buy one good one, than 2 or three smaller/cheaper gun. I would think if I take care of it, the gun will last a lifetime. |
|
| Author: | mattst18 [ Fri Jul 10, 2015 11:50 am ] |
| Post subject: | Re: Rivet guns |
I have a rivet gun, rivet sets and bucking bars I would be willing to sell. I purchased them from Rich Snelson 15 years ago. I am not sure if it is a 3x or 4x but I should be able to find out. Rich was our newsletter editor and said it was the correct size to build a Thorp. |
|
| Author: | flyingfool [ Fri Jul 10, 2015 12:19 pm ] |
| Post subject: | Re: Rivet guns |
Matt, Very nice offer. I sent you a PM |
|
| Author: | James Grahn [ Sat Jul 11, 2015 9:55 am ] |
| Post subject: | Re: Rivet guns |
I have a 4x, but I have a regulator in line with it. As rivets age, they can be harder to set. I really do not want to start that discussion again... Cubes |
|
| Author: | jrevens [ Sun Jul 12, 2015 12:51 am ] |
| Post subject: | Re: Rivet guns |
A 4x (with a regulator) is my all-around choice. A 5x is really nice for the center section spar. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|