Thorp Air Command - T18.net http://thorp18.com/thorpforum/ |
|
Looking for STANDARD wing main beams, spars, ribs etc http://thorp18.com/thorpforum/viewtopic.php?f=3&t=7958 |
Page 1 of 1 |
Author: | mmp1 [ Thu Jun 30, 2016 8:55 pm ] |
Post subject: | Looking for STANDARD wing main beams, spars, ribs etc |
Its Stretch, KAUN, N290MM, in the Sierra Nevada foothills. I marked my starboard inner panel for a flapless center wing at JW's barn using the blessed templates with Master Builder Neusel and Richard but I thought you'd all know the whereabouts of any STANDARD wing main beams, spars, ribs might be a-bouts? I talked to Al at KLFK about his bird without an engine. Do ya know that aircraft? He says some guy is comin' down from Wisconsin to looky-lou. ========= PARTING OUT THORP T18 • REDUCED FOR QUICK SALE • This T-18 complete airframe and full panel, one Radio, Al 936-707-3862 best offer NO EMAIL • Contact Al Lown , Owner - located Lifkin, TX USA • Telephone: 936-707-3862 . • Posted June 18, 2016 ========== Any STANDARD Thorp wing parts built to plans (.025 skins) would be obliged, fur nuff, Stretch KAUN N290MM Good fourth to everyone and your mates |
Author: | 1albee [ Fri Jul 01, 2016 6:55 am ] |
Post subject: | Re: Looking for STANDARD wing main beams, spars, ribs etc |
I have a complete undamaged wing (T) with flaps I would sell for $1500.00 near Sacramento, CA. Phil |
Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |