Thorp Air Command - T18.net
http://thorp18.com/thorpforum/

Folding wing photos
http://thorp18.com/thorpforum/viewtopic.php?f=10&t=7724
Page 1 of 1

Author:  ljkrume [ Tue Feb 24, 2015 1:27 am ]
Post subject:  Folding wing photos

Just posted a few photos of the folding wing joint in my album. Haven't seen too many other close-ups on this site. Hope it helps.

Les, in Albuquerque

Author:  jrevens [ Tue Feb 24, 2015 11:33 am ]
Post subject:  Re: Folding wing photos

That looks really good Les... nice work!

Author:  Ryan Allen [ Tue Feb 24, 2015 1:01 pm ]
Post subject:  Re: Folding wing photos

that all looks really good. The parts all look very professional! Out of curiosity, did you fabricate (what looks like to me) that u-joint type connection near the rear spar? That would seem difficult to precisely fabricate.

Author:  ljkrume [ Wed Feb 25, 2015 1:48 pm ]
Post subject:  Re: Folding wing photos

Don't know if you know, but the U-joint tube slides in and out to accomodate closing the gap between outer and center wing before installing the pin at the rear spar. The tube is hollow, but I pressed a solid plug in one end to machine the slot. The other part of the U-joint is milled with a slot also. Not too difficult. The U-joint does need to allow enough freedom on the wing to line up holes for the pin. Until you get it all worked out it takes a lot of on and off cycles with the wing. Good to have a helper for that.

Les.

Author:  Rich Brazell [ Wed Feb 25, 2015 4:54 pm ]
Post subject:  Re: Folding wing photos

If you need more photos of the folding gizmo , I have several in my photo section to graze upon . Les is right, a helper (my wife) sure helps a lot to get the wing into the flight position . When I am ready to bring it home I can fold the wings myself while on the trailer and then head home . ;)

RB O0 39

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/